P0112Intake Air Temperature Circuit Low Input
Oto co oznacza kod usterki P0112, dlaczego się pojawia i co z nim zrobić.
Układ: Fuel & air metering
Zwykle można bezpiecznie przejechać krótki dystans, ale jak najszybciej zleć to sprawdzić.
Co oznacza P0112
The signal voltage from the intake air temperature (IAT) sensor is lower than expected, which the computer reads as unusually hot intake air or a circuit fault. Because the sensor's resistance drops as temperature rises, a low voltage usually points to a short to ground in the wiring or a failed sensor. The mixture may be adjusted slightly wrong, but the effect is typically minor.
Typowe objawy
- Check engine light on
- Minor rough idle
- Slight hesitation
- Small fuel economy change
- Often no obvious symptoms
Typowe przyczyny
Uporządkowane od najczęstszych do najrzadszych.
- 1Short to ground in the IAT signal wiring
- 2Faulty IAT sensor
- 3Corroded or damaged connector at the sensor
- 4Internal short in the sensor
- 5Wiring chafed against a ground point
Co zrobić
Inspect the IAT wiring and connector for a short to ground or damage, then test or replace the sensor. Compare the sensor reading to the actual air temperature to confirm. This is a low-severity code, so the car is safe to drive, but repair it for correct fueling.
Kupujesz auto z kodem P0112?
Zapisany kod usterki może wskazywać na ukryty problem. Zdekoduj VIN, aby bezpłatnie poznać dane auta i oficjalne akcje przywoławcze dotyczące bezpieczeństwa.
Najczęściej zadawane pytania
Co oznacza kod P0112?
The signal voltage from the intake air temperature (IAT) sensor is lower than expected, which the computer reads as unusually hot intake air or a circuit fault. Because the sensor's resistance drops as temperature rises, a low voltage usually points to a short to ground in the wiring or a failed sensor. The mixture may be adjusted slightly wrong, but the effect is typically minor.
Co powoduje kod P0112?
Najczęstsze przyczyny to: Short to ground in the IAT signal wiring, Faulty IAT sensor, Corroded or damaged connector at the sensor, Internal short in the sensor, Wiring chafed against a ground point.
Czy można bezpiecznie jechać z P0112?
Zwykle można bezpiecznie przejechać krótki dystans, ale jak najszybciej zleć to sprawdzić.
Jak naprawić kod P0112?
Inspect the IAT wiring and connector for a short to ground or damage, then test or replace the sensor. Compare the sensor reading to the actual air temperature to confirm. This is a low-severity code, so the car is safe to drive, but repair it for correct fueling.
To ogólne informacje, które pomogą Ci zrozumieć kod P0112, a nie zastępstwo dla diagnostyki przez wykwalifikowanego mechanika. Zawsze potwierdź przyczynę, zanim wymienisz części.
Definicje kodów są zgodne ze znormalizowaną listą OBD-II (SAE J2012). CarVinVin jest niezależny i nie jest powiązany z żadnym producentem.