P0122Throttle/Pedal Position Sensor/Switch "A" Circuit Low
Oto co oznacza kod usterki P0122, dlaczego się pojawia i co z nim zrobić.
Układ: Fuel & air metering
Zwykle można bezpiecznie przejechać krótki dystans, ale jak najszybciej zleć to sprawdzić.
Co oznacza P0122
The voltage on the throttle or pedal position 'A' circuit is lower than the allowed minimum. This usually means a short to ground, an open circuit, or a lost reference voltage. The computer reads the throttle as essentially closed or invalid.
Typowe objawy
- Check engine light on
- Reduced power / limp mode
- Hesitation or no response to throttle
- Erratic or stuck idle
- Stalling
Typowe przyczyny
Uporządkowane od najczęstszych do najrzadszych.
- 1Wiring shorted to ground or open in the signal wire
- 2Faulty throttle/pedal position sensor
- 3Loss of 5-volt reference or poor ground to the sensor
- 4Corroded or loose connector
- 5Faulty throttle body assembly (electronic throttle)
Co zrobić
The vehicle may run in limp mode with reduced power, so drive carefully and get prompt diagnosis. A technician should check the signal and reference voltages and inspect for shorts, opens, and bad connectors. Repair wiring or replace the sensor/throttle body as indicated.
Kupujesz auto z kodem P0122?
Zapisany kod usterki może wskazywać na ukryty problem. Zdekoduj VIN, aby bezpłatnie poznać dane auta i oficjalne akcje przywoławcze dotyczące bezpieczeństwa.
Najczęściej zadawane pytania
Co oznacza kod P0122?
The voltage on the throttle or pedal position 'A' circuit is lower than the allowed minimum. This usually means a short to ground, an open circuit, or a lost reference voltage. The computer reads the throttle as essentially closed or invalid.
Co powoduje kod P0122?
Najczęstsze przyczyny to: Wiring shorted to ground or open in the signal wire, Faulty throttle/pedal position sensor, Loss of 5-volt reference or poor ground to the sensor, Corroded or loose connector, Faulty throttle body assembly (electronic throttle).
Czy można bezpiecznie jechać z P0122?
Zwykle można bezpiecznie przejechać krótki dystans, ale jak najszybciej zleć to sprawdzić.
Jak naprawić kod P0122?
The vehicle may run in limp mode with reduced power, so drive carefully and get prompt diagnosis. A technician should check the signal and reference voltages and inspect for shorts, opens, and bad connectors. Repair wiring or replace the sensor/throttle body as indicated.
To ogólne informacje, które pomogą Ci zrozumieć kod P0122, a nie zastępstwo dla diagnostyki przez wykwalifikowanego mechanika. Zawsze potwierdź przyczynę, zanim wymienisz części.
Definicje kodów są zgodne ze znormalizowaną listą OBD-II (SAE J2012). CarVinVin jest niezależny i nie jest powiązany z żadnym producentem.